How To Adjust Rear Derailleur Sram. After opening up your shifter pod SRAM X0 x-9 x-7 its just a matter of loosening up the single screw on the pod pulling the cable out and inserting a new cable replace cap. Using the bolt on the rear of the rear derailleur you need to adjust the gap between the top pulley of the derailleur and the bottom of the cassette on both the high and low end.
SRAM XO 11-speed rear derailleur. Limit screws are fine. Make this adjustment by pushing the rear derailleur to the largest cog by hand.
Played with the B-screw setting it to spec jockey wheel 12-16mm below the big cog per the SRAM install manual and back to where it was when I got it more like 8 - 10mm.
Riders want the derailleur to do its job shifting on command whether under climbing load or the stage finish. Spacing between derailleur pulleys and cogs. Using the bolt on the rear of the rear derailleur you need to adjust the gap between the top pulley of the derailleur and the bottom of the cassette on both the high and low end. There is no barrel adjuster on the derailleur but one can be.
